A closed valve in the brake line between the locomotive and the coaches may explain why the Kolkata-Sairang Express could not be stopped before it derailed at Digaru station in Assam on 11 November, a preliminary railway inquiry has found. The Railway Board has since ordered all zonal railways to check how locomotive crews test their brakes.
What the inquiry found
A six-member committee of the Northeast Frontier Railway (NFR) inspected the site on the day of the accident. It found that the FP/BP angle cock linked to the power car was in the isolated, or closed, position, according to the report as cited by The Indian Express. The feed pipe (FP) and brake pipe (BP) carry compressed air from the locomotive down to the last coach, and the brakes work by changing that air pressure.
"This may have been the reason for the accident, as the brakes may not have been applied when the FP/BP angle cock of the locomotive was in the isolated position," the report said. It added that the loco pilot's brake application may have failed because the cock was already shut.
The Assam Tribune, carrying a PTI report, said the inquiry has not yet established who left the braking system in that state, or whether the crew skipped mandatory checks.
How the journey unfolded
The derailment happened at about 6.54 am, when the locomotive and five coaches came off the track at Digaru, on the Guwahati-Lumding line. The inquiry traced the train's 33-km run from Guwahati.
- At Thakurkuch, the front wheel of the first coach behind the engine was found red hot and smoking. The report said the power car's hand brake may not have been fully released.
- At Panbari, about seven kilometres on, the train stopped again. The assistant loco pilot and a pointsman checked for brake binding and released the brakes.
- Around seven kilometres later, the train was meant to pull into the loop line at Digaru to let the Jorhat Town Jan Shatabdi Express pass. Instead, it overshot the red signal and derailed.
According to the report, the loco pilot and his assistant tried several brakes, including the emergency and regenerative brakes, without success. The guard's attempt to brake from his van also failed. Loco pilot Mantu Bhowmick said in his statement that none of the brakes they tried worked.
Unnamed officials quoted in the PTI report gave a possible explanation: locomotives used to be changed at Guwahati, and staff there would isolate the angle cock as part of that routine. After the route was electrified, the same electric engine began running beyond Guwahati. A staff member who had been on leave during the change allegedly returned on 11 November and isolated the cock out of habit. This account has not been officially confirmed.
Railway Board orders nationwide brake checks
In a direction dated 11 November, the Railway Board told zonal railways that running crews must carry out braking tests after taking charge of a train. The board described this as a restatement of existing rules and said compliance appeared to have been overlooked in this case.
Zonal railways are running a safety drive from 12 to 18 November to check brake feel and brake power tests by locomotive crews. "Any discrepancies noticed in this regard should be collated and forwarded to the Railway Board by 20-11-2026," the direction said. It also states that the loco pilot "shall observe the effectiveness of brakes and brake power of the train."
Why it matters
The early findings point to a procedural lapse rather than a track or signal fault. If confirmed, the case shows how a routine step can become dangerous when operating practice changes, as it did when electric engines began running through Guwahati.
What happens next
The findings are preliminary. The NFR inquiry is expected to fix responsibility, and the Railway Board will review lapses reported by zones after the drive ends on 18 November.
PS · NLBRT, CC BY-SA 4.0



